Quick Guide To Using Your Receiver; Operation; Changing Channels - THOMSON THC300 User Manual

and press Ok to enter the Auto Scan menu. Press pq tu to set Country and Network
and then highlight Search. Press Ok to start the auto search.
Some operators in Germany are pre-installed.
4.1.3 Lcn
If LCN (Logical Channel Numbering) is activated and an LCN signal is provided by
the operator, channels will be stored in an operator defined order. Set LCN to On to
activate the operator defined channel numbering or Off to store channels in the found
order. This function only applies when a new channel search is performed.
TiP:

5.0 Quick GuiDe TO usinG YOuR ReceiveR

We at THOMSON understand that you can't wait to enjoy your digital HD cable
receiver. The following quick guide will make you familiar with the basic operation
of this device. We do, however, advice you to read the full manual to get the best
performance from your receiver.
To turn your receiver ON or to Standby, use the q button on the remote control.
Choose a channel with the pq buttons. Alternatively, you can digit the channel
number with the 0~9 buttons on the remote control or press Ok in viewing mode to
display the channel list. The volume can be adjusted with the tu buttons.

6.0 OPeRATiOn

6.1 changing channels

Following ways are possible for changing channels with your new receiver:
• Via direct access using the 0~9 buttons.
• Via the channel list using Ok and the PG+/PG- buttons.
• Via the pq buttons.
6.1.1 Direct access via 0~9 buttons
To gain direct access to a certain channel, simply input its number with the 0~9
buttons on the remote control. Channel numbers can be up to four digits long.
Entering a number with less than four digits is possible. Just wait a few seconds
and your receiver will switch to the selected channel or press Ok immediately after
selecting the channel number.
P10
Quick GuiDe TO usinG YOuR ReceiveR
If the Welcome menu does not appear after switching on the
receiver the first time, reset the receiver to factory settings by
pressing the Menu button and selecting Load Factory Setting
in the submenu Tools. (DeFAuLT Pin: 1234).