Table of Contents
Advertisement
NOTE:
5.0 QUICK GUIDE TO USING YOUR RECEIVER
We at STRONG understand that you can't wait to enjoy your new high definition digital
terrestrial receiver. The following quick guide will make you familiar with the basic operation of
this device. We do, however, advice you to read the full manual to get the best performance
from your receiver.
To turn your receiver ON or to Standby, press q on the remote control.
Choose the desired channel with pq. Alternatively, you can press the channel number with the
0~9 buttons on the remote control or press OK in viewing mode to display the channel list. The
volume can be adjusted with t u.
6.0 OPERATION
Your new receiver is equipped with several features to make watching TV a true pleasure. This
paragraph describes these features. Please do also read chapter 7.0 to get familiar with the
menu of your receiver.
6.1 Changing channels
Following ways are possible for changing channels with your new receiver:
- Via direct access using the 0~9 buttons.
- Via the channel list through OK and the CH+/CH- buttons.
- Via the pq buttons.
6.1.1 Direct access via 0~9 buttons
To gain direct access to a certain channel, simply enter its number with the 0~9 buttons on the
remote control. Channel numbers can be up to four digits long. Entering a number with less
than four digits is possible. Just wait a few seconds and your receiver will switch to the selected
channel or press OK immediately after selecting the channel number.
6.1.2 TV list
Press OK in viewing mode to display the TV list. Use pq in the channel list to highlight your
channel of choice and press OK once to select the highlighted channel. Press OK again to leave
the channel list mode. Inside the channel list it is possible to use the CH+/CH- buttons as well
in order to scroll page-wise through the list to speed up.
NOTE:
10
If the Welcome menu does not appear after switching on the
receiver for the first time, reset the receiver to factory settings by
pressing the MENU button and selecting Load Factory Setting in
the menu Installation. (DEFAULT PIN: 0000).
Use t u to toggle between the All Channel list and the favourite
list(s) or press FAV in viewing mode for a list of available favourite
lists.
Advertisement
Table of Contents
