Table of Contents
Advertisement
Scan mode:
Connection:
*Availability of DVB/HoH subtitles depends on the broadcast. If such subtitles are not supported, then most likely
subtitles can be activated via Teletext if available.
When all settings have been made, move the highlight to OK and press OK to continue.
NOTE:
The receiver will now advance to the Aerial Adjustment screen.
This part of the wizard is of great help when setting up your antenna system.
Use pq to move the highlight to the setting you wish to alter and use tu to change values.
The following settings are available:
Antenna Power:
Beeper:
Channel No.:
When all settings have been made, press OK to start scanning.
The receiver will search for all available channels now. Once scanning is finished, the receiver
switches to viewing mode.
TIP:
5.0 QUICK GUIDE TO USING YOUR RECEIVER
We at STRONG understand that you can't wait to enjoy your new high definition digital
terrestrial receiver. The following quick guide will make you familiar with the basic operation
of this device. We do, however, advice you to read the full user manual to get the best
performance from your receiver.
To turn your receiver ON or to Standby, use the q button on the remote control.
Choose the desired channel with the pq buttons. Alternatively, you can digit the channel
number with the 0~9 buttons on the remote control or press OK in viewing mode to display
the channel list. The volume can be adjusted with the tu buttons.
8
Select All to store scrambled and free to air channels or select Free
to store only free to air channels. Note: Scrambled channels cannot
be viewed with this receiver.
Use this option to adjust the established connection to your TV set.
Select HDMI or TV SCART.
Wrong region selection can lead to missing channels or channels
being stored at wrong positions in the channel list.
Set to On if you use an active antenna. When set to On, 5 V will
be present at the ANT IN connector of the receiver. Select Off for
passive antennas.
Select On for an audible indication of signal reception. Off turns the
beeper off.
Select a channel that is known to carry a broadcast in your region.
The Signal Strength and Signal Quality bars give a visual indication
of the reception. Adjust your antenna to obtain maximum signal
strength and quality.
If the Welcome menu does not appear after switching on the
receiver the first time, reset the receiver to factory settings by
pressing the MENU button and selecting Load Factory Setting in
the submenu Tools. (DEFAULT PIN: 1234).
Advertisement
Table of Contents
