Tools - THOMSON THC300 User Manual

Timer Service:
Wakeup Channel:
Wakeup Date:
Wakeup Time:
Duration:
When all settings have been made, use pq to move the highlight to Save and press
Ok to confirm. To quit the timer without saving your settings, move the highlight to
Cancel.
7.3.5 Parental Lock
This menu allows you to protect the installation menu and/or channels with a PIN
code. You can also enter a new PIN code in the Parental Lock menu.
Use pq to select Parental Lock from the System Setup menu and press Ok to proceed.
You will be asked to enter your PIN code. (DeFAuLT Pin: 1234)
Menu Lock:
Parental Rating:
New Password:
Confirm Password:
7.3.6 OsD setting
This menu allows you to change settings for: OSD Timeout and OSD Transparency.
OSD Timeout:
OSD Transparency:
Load Default OSD Setting: Press Ok to clear all OSD settings and reset to default values.
7.3.7 Auto standby
Auto Standby is a new feature that helps you reducing power consumption. When
set to 30Min/1 Hour/2 Hours or 3 Hours, the receiver will switch to standby if it doesn't
receive any commands during this time. Set Auto Standby to Off to deactivate the
automatic standby function.

7.4 Tools

Press Menu in viewing mode to enter the Main Menu.
Select the Tools submenu with pq and press Ok or u to enter.
Use pq to highlight the submenu of choice and press Ok proceed.
Choose between Channel (the timer will wake up the receiver)
or Record (Timer will start recording the scheduled event).
Use tu to select the channel the timer will wake up with.
Use the 0~9 buttons to enter the date for the timed event.
Use the 0~9 buttons to enter the starting time.
Use the 0~9 buttons to enter the duration of the timer.
Locks the installation menu. You can set Menu Lock to On or
Off.
Choose between: Off, 4 years and up to 18 years. Channels
with a parental rating above the chosen age will be protected
with a PIN code (if available in your local broadcast.)
Enter your new PIN code (4 digits) here.
Re-enter your PIN code here to confirm.
Sets the duration time of on screen banners and messages
remove. The range is 1~10 seconds or Always On.
To set the OSD transparency from Off ~ 40% with 10% steps.
P19
MAIN MENU