Keyboard Wedge Interface - Intermec SG20B User Manual

Chapter 3 — Connect the Scanner and Base Station as a System

Keyboard Wedge Interface

32
The SG20 Bluetooth Base Station is successfully connected and
power is on when it emits 2 blue flashes.
5 If necessary, configure the serial parameters of your base station
using EasySet to match the host device (for more information on
serial parameters setup, see
page 43).
For a keyboard wedge interface the keyboard wedge Y-cable is
connected to the 10-pin modular connector. If your host does not
provide enough power you can connect an external power supply to
the Y-cable. This will power your base station but will not provide
enough power to charge a scanner in the base. To charge a scanner
(fast charge) you must connect an external power supply to the DC
connector.
To connect with a keyboard wedge Y-cable
1 Turn off your host device.
Do not connect a keyboard wedge Y-cable to a host that is
turned on. You may damage your product.
2 Connect the Y-cable to the 10-pin modular connector of your base
station and to the host device (one end to the host and the other to
a PS2 keyboard).
SG20B Cordless Scanner + Bluetooth Base Station User's Guide
"RS-232 Interface Settings" on