Hunter Type 2A Series Owner's Manual And Installation Manual page 17

9 • Completing Your Installation With or Without a Bowl Light Fixture (Continued)
Uninstalling the Light Fixture
9-14. To uninstall the light fixture, first disconnect the plug
connectors between the black wire and the black/white wire.
9-15. Disconnect the plug connectors between the two white
wires.
9-16. Uninstall the connector and washer from the end of the
socket inside the lower switch housing.
9-17. Unscrew the threaded rod of the socket from the lower
switch housing.
9-18. Remove the socket from the lower switch housing pulling
disconnected wires through the hole in the center of the
lower switch housing.
Note: When removing the wires, pull the thin plug
connector (male) through first, and then pull the other plug
connector (female) through the hole.
9-19. Install the dummy terminals (included in the sack parts) on
the two disconnected wires in the lower switch housing.
9-20. Remove the two screws attaching the light kit to the lower
switch housing.
9-21. Remove the light fixture from the lower switch housing,
9-22. Install the switch housing cap and plug button to the lower
switch housing.
9-23. Once you have uninstalled the light fixture, continue
with step 9-6.
Switch Housing
Cap
Step 9-22
Plug Button
Male Dummy
Terminal
Female Dummy
Terminal
17
42885-01 • 03/30/10 • Hunter Fan Company
Nut
Male / Female
Terminals
(shown
disconnected)
Light Kit
Step 9-14 – 9-18
Step 9-19 – 9-21
Washer
Socket