Hunter Type 2A Series Owner's Manual And Installation Manual page 16

9 • Completing Your Installation With or Without a Bowl Light Fixture
Installing the Glass Bowl
9-8. Install the included bulb.
9-9. Thread the light and fan pull chains through the
hole in the center of the glass bowl.
9-10. Place the cover plate up against the glass bowl.
Align the holes in the cover plate and glass
bowl.
9-11. Thread the fan pull chain and light pull chain
through the appropriate holes.
9-12. Screw the finial onto the threaded rod end
until tight.
9-13. Attach the extra pull chains (included) to
the light and fan pullchains using the plastic
breakaway connector. (You may find the plastic
breakaway connector on theend of the extra
chain.)
Note: In compliance with Canadian energy regulations, this ceiling
fan contains a device that restricts the light kit to a maximum
of 190 Watts. Exceeding that limit or the marked limit on this
product may result in fire hazard or improper operation.the
troubleshooting section
Step 9-8
Fan
Pull Chain
Fan
Pull Chain
Cover Plate
16
42885-01 • 03/30/10 • Hunter Fan Company
Light Bulb
(Pin Base CFL)
Light
Pull Chain
Light
Pull Chain
Finial
Breakaway
Connector