Troubleshooting; Replacing Powerbrush Belt - Bissell 1716 SERIES Spot Lifter User Manual

M
aintenance and care (continued)
Storage
Store in a dry area, at room temperature
to avoid freezing.
To replace the powerbrush belt
If the belt should break, to replace:
1.
Remove the screw in the belt cover using a
Phillips Screwdriver.
2.
Remove the broken belt.
3.
Replace the new belt over the 2 belt gears.
4.
Replace the belt cover door.
WARNING:
To reduce the risk of
fire, electric shock or
injury, unplug from outlet
before servicing.
T
roubleshooting
Cleaner won't run
Possible causes
1.
Power cord not plugged in
2. Blown fuse/tripped breaker
3.
C.I.D. needs to be reset
Reduced spray or no spray
Possible causes
1.
Spray nozzle clogged
2. Solution tank empty
3.
Tank not inserted properly
Deep cleaner won't pick up cleaning solution
Possible causes
1. Collection tank is full
2.
Collection tank drain plug is loose
w w w . b i s s e l l . c o m
ug120-4060_1716_908.indd 9
Tip:
If you do not have the Brush
Cartridge in all the way, the
Dual PowerBrushes will not
rotate. Firmly push the
cartridge in place, while
listening for the "snap" to
assure proper placement.
1.
WARNING:
Do not use an extension cord with this
product. The use of an extension cord may
result in a severe electrical shock, particularly
if the extension cord does not have an
electrical rating higher than that of the
product, OR if the extension cord does not
have a three-prong grounding plug and if
the extension cord is not plugged into a
circuit box with a ground fault circuit inter-
rupter. Safety precautions such as keeping all
connections off the ground and dry will not
eliminate the danger.
Remedies
1. Check electrical plug
2. Check/replace fuse or reset breaker.
3. Reset C.I.D. (page 5).
Remedies
1. Clean spray nozzle
2. Check/refill tank
3. Make sure tank is inserted properly
Remedies
1. Empty collection tank
2. Check plug for snug fit
8 0 0 . 2 3 7 . 7 6 9 1
9
10/14/08 1:02:12 PM