Emptying Collection Tank; Cleaning Dual Powerbrush; Machine Care - Bissell 1716 SERIES Spot Lifter User Manual

M
aintenance and care

Machine care

1.
Turn the power switch to the "OFF"
position. ( O )
2.
Unplug the unit.
3. Carry the Spot Lifter PowerBrush to the sink
or drain.
To empty the collection tank
1. Begin by removing the solution tank. Gently
press the quick release tabs on the solution
tank and slide the tank off of the unit.
2. Grasp the collection tank and pull to
remove.
3.
While at the sink, remove the tank cap by
unscrewing and lifting out.
4.
Empty the tank. Rinse the collection tank
with warm water.
5.
Replace cap by turning to the right, until snug.
6.
Slide the collection tank into the unit.
Replace the solution tank.
Note: If a significant amount of water and
formula remains in the solution tank, you
may leave it in the solution tank for your
next cleaning task.
To clean the dual powerbrush
NOTE: Make sure the Power Switch is in
the "OFF" ( O ) position and the unit is
unplugged.
1.
Firmly grasp the brush cartridge from the
side of the unit and pull out from the unit.
2.
To remove any debris that may have
collected around the dual PowerBrushes,
rinse the brush cartridge under
warm water.
3.
Replace the brush cartridge into the unit
by gently guiding the cartridge in the unit.
Once it is in place, firmly "snap" the brush
cartridge in place.
NOTE: Do not attempt to remove or insert
the brush cartridge while the unit is
running. This will damage your unit.
8
w w w . b i s s e l l . c o m
ug120-4060_1716_908.indd 8
1.
2.
3.
1.
2.
8 0 0 . 2 3 7 . 7 6 9 1
10/14/08 1:02:12 PM