Table of Contents
Advertisement
1.
Select the source you want to take on-air by
pressing a source button on the Program bus.
Note:
• You can not preview the next source on your
preview monitor when cutting on the Program Bus.
Configuring the Auto Trans Rate
You can control the amount of time a dissolve or wipe
transition takes to complete when you press the
AUTO TRANS button. Transitions performed with the
Fader are not affected.
To change the rate for automatic transitions:
1.
Prepare a transition using DISS , WIPE, or DVE
as the transition type, but do not perform the
transition.
2.
Use the Time knob to change the transition
duration. The duration is specified in frames.
3.
Press AUTO TRANS to perform the transition.
Note:
• You can set different transition rates for the
dedicated KEY TRANS buttons.
For More Information on...
• dedicated key transitions, refer to the section
"Dedicated Key Transitions" on page 25.
Wipe Transitions
You can select from a number of predefined patterns
and control the amount of time a wipe transition takes
to complete.
22
2
1
3
To perform a wipe transition:
2
1
1.
Prepare a transition using WIPE as the type of
transition, but do not perform the transition.
2.
Select the pattern you wish to use for the wipe.
3.
Use the Time knob to change the transition
duration.
4.
Press AUTO TRANS to perform the transition.
For More Information on...
• preparing transitions, refer to the section
"Transition Overview" on page 21
• modifying Wipe transitions, refer to the section
"Modifying Wipes" on page 29
DVE Transitions
You can select from a number of predefined patterns
and control the amount of time a DVE transition takes
to complete.
To perform a DVE transition:
2
1
1.
Prepare a transition using DVE as the type of
transition, but do not perform the transition.
2.
Select the DVE effect you wish to use for the
transition by pressing or double-pressing a Wipe
3
4
3
4
Hide quick links:
Advertisement
Table of Contents
