Advanced Operation; Transition Limit; Modifying Wipes - JVC KM-H3000 User Manual

Advanced Operation

This chapter describes advanced operating concepts
for your switcher. Advanced topics and information on
modifying basic concepts to fit your requirements are
discussed.

Transition Limit

You can stop a transition at a preset position between
the two Fader limits. With the transition limit enabled,
an automatic transition will stop when it reaches the
defined limit.
To define the transition limit point:
1. Press DISS , WIPE, or DVE.
2. Move the Fader to the desired position you wish
to set as a transition limit.
3. Press the Limit knob.
The Progress Bar next to the Fader flashes to
indicate the defined transition limit.
Note:
• Ensure that you are not on-air when setting the
transition limit as you will be moving the Fader
handle to define the preset position.
To perform a transition with a transition limit set:
1. Initiate a transition by pressing AUTO TRANS.
When the transition reaches the defined limit, it
will stop.
2. To reverse the transition, press AUTO TRANS.
3
2
3
1
3. To continue the transition, press the Limit knob
to turn off the transition limit.
4. Press AUTO TRANS to complete the transition.
To Quickly Reset the Transition Limit
• Double-press the Limit knob.
The transition limit is reset to 50% and the trans
limit feature is turned off.

Modifying Wipes

Wipes can be modified to give more distinct qualities
and personalize your transitions. The following effects
can be adjusted:
• Time, Direction
• Pattern, Horizontal Multiplication, Vertical
Multiplication
• X-Position, Y-Position, Aspect Ratio
• Border, Border Color, Border Softness
• Hue, Saturation, Luminosity
• Rotation
To modify time and direction:
2
1
1. Press WIPE to display the Wipe menu.
2. Press NEXT until Time is displayed.
3. Use the Time knob to change the duration of the
wipe.
4. Use the Dirctn knob to set the direction of the
wipe. You can choose from the following:
• Fwd — Wipe runs in the forward (default)
direction.
• Rev — Wipe runs in the reverse direction.
5. Press the Direction knob to alternately enable
and disable the flip-flop direction feature. You
can choose from the following:
• Enabled (FF) — The first time a wipe
transition is performed, it runs in the forward
direction. Performing a second wipe transition
runs in the reverse direction.
• Disabled — Wipes always run in the direction
specified in step 4 above.
3 4
29