JVC KM-H3000 User Manual page 22

DVE Resource Capturing
Capturing a DVE resource for a new key or transition
takes the DVE resources from the following sources
in order of availability:
• Transition area if no DVE transition is in progress.
• Off-air DVE key (highest key resource is taken
first)
• On-air DVE key (current DVE Key is converted to
an Auto-Select key and taken off-air).
• Transition area if a DVE transition is in progress.
The transition is converted to a dissolve transition.
Field Switch Selection
The field switch selection feature allows you to select
when the switcher triggers a transition from one video
source to the next when you are running in an
interlaced video format. Each interlaced video frame
is composed of an odd field and an even field and you
can specify that transitions are initiated on:
• even fields only
• odd fields only
• either even or odd fields
If you are running in a progressive scan video format,
setting your switcher to transition on even or odd
fields will cause the switcher to only allow transitions
on every second frame.
To set when the switcher initiates transitions:
2
1
3
1. Press MENU.
2. Press the SYSTEM Wipe Pattern button.
3. Press NEXT until FldSwt (FrmSwt if you are
using a progressive scan video format) is
displayed.
4. Use the FldSwt (FrmSwt if you are using a
progressive scan video format) knob to select
when transitions are initiated. You can choose
from the following:
• F1 — Field 1 (Odd Field) transitions are
initiated on odd fields.
• F2 — Field 2 (Even Field) transitions are
initiated on the even fields.
• BOTH — Transitions can be initiated on either
even or odd fields or frames.
18
4
5. Press the FldSwt (FrmSwt if you are using a
progressive scan video format) knob to commit
the selection.
Editor Control
Your switcher can be controlled by external editors
using the GVG100 protocol. You can enable or
disable external control.
To enable or disable external editor control:
1
2 3
1. Press MENU.
2. Press the PERS Wipe Pattern button.
3. Press NEXT until Editor is displayed.
4. Use the Editor knob to enable or disable
external editor control. You can choose from the
following:
• GVG100 — Editor control is enabled.
• G100L — Legacy editor control is enabled.
• Off — Editor control is disabled.
For More Information on...
• external editor control, refer to the section "Editor
Port" on page 43.
Next Transition Area Reset
You can choose the state of the Next Transition area
after a transition is performed.
To set the Next Transition Area reset behavior:
1
2 3
1. Press MENU.
2. Press the PERS Wipe Pattern button.
3. Press NEXT until Trans is displayed.
4
4