Table of Contents
Advertisement
Other Recording Functions
On the unit:
XL – R5020 CD/CDR MULTIPLE COMPACT DISC RECORDER
COMPACT
DIGITAL AUDIO
FINALIZE
7 7 7 7 7 Setting auto-stop for analog Synchronized Recording
When using Synchronized Recording for recording from
analog sources, you can stop recording automatically as well
as starting. To use this function, follow the procedure below.
Recording stops if weak signal that this unit cannot detect
comes in for more than 6 seconds.
• When you purchase this unit, Synchronized Recording for
analog sources is set to start automatically, but not to stop.
Available sources
CD ANALOG, LINE IN, MIC IN, CD+LINE MIX, CD+MIC MIX,
LINE+MIC MIX
1
While 3-CD Changer and CD Recorder are in stop
mode, press MENU.
2
Turn MULTI JOG ¢ / 4 on the unit or press 3
or 2 on the remote control until "ANALOG
SYNC" appears on the display, then press SET.
"START" (initial setting) is flashing on the display.
• To cancel the setting, press CANCEL.
3
Turn MULTI JOG ¢ / 4 on the unit or press 3
or 2 on the remote control to select
"START&STOP" then press SET.
To use Synchronized Recording only for the starting,
select "START" in step 3.
MULTI JOG ¢ / 4
COMPACT
DIGITAL AUDIO
Recordable
ReWritable
CANCEL
MENU
SET
Remote control:
1
4
7
10
PLAY
MODE
3 / 2
CD REC CD EDIT SYNCHRO
REC
FINALIZE
REC MUTING
7 7 7 7 7 Finalizing a disc—CD-R/CD-RW
Finalization is the final process in recording on a CD-R or
CD-RW. "Finalizing a disc" means writing the TOC (Table of
Contents) on the recorded disc.
Only after this process is completed, a recorded CD-R or
CD-RW can be played back on a CD player compatible with
CD-R/CD-RW.
IMPORTANT
• Once a CD-R has been finalized, no further recording
can be made on the disc.
• When you unplug the power cord or when a power
failure occurs during finalization process, recorded data
will be lost and the disc may not be utilized any more if
it is a CD-R.
1
Load a recorded disc you want to finalize onto
the CD Recorder disc tray.
2
While 3-CD Changer and CD Recorder are in stop
mode, press FINALIZE.
"FINALIZE?" appears on the display.
• If a finalized disc is loaded, "ALREADY FINAL" appears
on the display.
3
Press FINALIZE again to finalize a disc.
Finalization starts. The REC indicator lights up and the 3
indicator and "FINALIZE" start flashing on the display.
• Finalization requires a few minutes to complete. (When
the disc is finalized, the REC indicator goes off, and the
3 indicator and "FINALIZE" stop flashing then go off.)
To cancel the finalization, press CANCEL in step 2.
To unfinalize CD-RWs, see "Unfinalizing a disc—only for
CD-RW" on the next page.
2
3
5
6
8
9
10
GROUP
CONTROL
REPEAT
CD
CDR
MENU
GROUP
SET
SET
CANCEL
GROUP
FADE
FINALIZE
PITCH 0
PITCH
33
Advertisement
Chapters
Table of Contents
