Usb Storage - JVC KM-H3000 User Manual

To restore factory defaults:
1
2 3
1. Press MENU.
2. Press the RESET Wipe Pattern button.
3. Press NEXT.
4. Press the Factry Reset knob.
5. Press the Confrm knob to perform the reset.
Press the Cancel knob to cancel the reset.

USB Storage

You can use the USB port to:
• Save and load memory sets to a USB drive
• Perform software upgrades
These files and settings can be copied and
backed-up on a standard computer.
Note:
• Wait 5 seconds after inserting a USB drive into the
USB port before using it.
For More Information on...
• performing software upgrades, refer to the section
"Software Upgrades" on page 37.
Saving Memory Banks and Registers
You can save up to 9 sets of up to 100 memory
registers on a USB drive.
To save memory registers to a USB drive:
2
3 5
1. Insert a USB drive into the USB port.
2. Press MENU.
3. Press the SAVE Wipe Pattern button.
4. Press the Mems knob to display the Save
Memory menu.
36
4
4
5. Press NEXT to cycle through the sets.
6. Press the knob for the set you want to save the
memory registers to.
7. Use the left knob to select which memory
registers you wish to save. You can choose from
the following:
• All — All switcher memory banks and
registers are stored to the selected set on the
USB drive.
• Bank — You can specify which switcher
memory bank is stored and in which bank in
the selected set it is stored to on the USB
drive.
• Indiv — You can specify which switcher
memory register is stored and in which
register in the selected set it is stored to on the
USB drive.
8. If you selected Indiv or Bank, select the memory
bank or register to store as follows:
• If you selected Indiv, use the Local knob to
select the memory register you wish to save.
The selected register is indicated as X.Y
where X is the memory bank and Y is the
memory register. Use the USB knob to select
the memory register on the USB drive you
wish to save to.
• If you selected Bank, use the Local knob to
select the memory bank you wish to save. Use
the USB knob to select the bank on the USB
drive you wish to save to.
9. Press the left knob to commit the save.
10. Press The Confrm knob to perform the save.
Press the Cancel knob to cancel the save.
Note:
• You do not need to store memory banks or
registers to the same memory banks or registers
on the USB drive.
• If you save an empty memory bank or register, the
destination bank or register on the USB drive is
erased.
Loading Memory Banks and Registers
Once the memory registers are loaded, you can recall
them for use.
To load memory registers from a USB drive:
2
3 5
4