Output Configuration; Clean Feed; Ip Address - JVC KM-H3000 User Manual

Output Configuration

The switcher has the following outputs:
• 2 Program Out HD-SDI
• 1 Preview Out HD-SDI
• 3 Auxiliary Out HD-SDI
• 1 Analog (NTSC or PAL) Out
The analog output allows the switcher to output
signals in NTSC and PAL formats. It can be routed
from the Preview, Program, Aux, or any of the primary
inputs. The analog output is not aspect ratio
converted. Downconversions from 16:9 HD sources
display as 16:9 SD video.
To configure the analog output:
2
1
1. Press MENU.
2. Press the SYSTEM Wipe Pattern button.
3. Press the Analog Out knob to display the
Analog Out menu.
4. Use the AnOut knob to select the source. You
can choose from the following:
• Prview — Preview bus output.
• Progrm — Program bus output.
• Aux 1 - 3 — Aux bus 1-3 outputs.
• In 1 - 12 — Inputs 1-12 (KM-H3000 only).
• In 1 - 6 — Inputs 1-6 (KM-H2500 only).
5. Use the AnMode knob to set the appearance of
the analog output. You can choose from the
following:
• Full — Full screen display.
• LtrBox — Letter box display.
Note:
• If your switcher is operating in a 4:3 aspect ratio,
you can not set the analog output to letter box.

Clean Feed

Clean Feed provides a second program output that is
derived from a different location than the standard
program output. Using the Clean Feed allows you to
4 5 3
remove particular keys without affecting the primary
program output. Typical applications are:
• Multilingual and live-to-tape productions
• Recording call-in shows for later airing without
telephone numbers displayed
To configure Clean Feed:
2
1
1. Press MENU.
2. Press the SYSTEM Wipe Pattern button.
3. Use the CLEAN knob to select where in the
output stream the Clean Feed is derived. You
can choose from the following:
• Key 1 — Clean Feed output is taken before
any keys are added.
• Key 2 — Clean Feed output is taken after Key
1 but before Key 2 or 3 is added.
• Key 3 — (KM-H3000 only) Clean Feed output
is taken after Key 1 and 2 but before Key 3 is
added.
Note:
• There is no physical Clean Feed output. The Clean
Feed signal is available from any Aux Bus.
For More Information on...
• Accessing the Clean Feed output on an Aux Bus,
refer to the section "Selecting a Special Source for
the Aux Buses" on page 42.

IP Address

The switcher is equipped with an Ethernet port to
allow remote access. By default, the switcher uses
DHCP to automatically obtain an IP address. You can
manually set an IP address, network mask, and
default gateway if your network does not have a
DHCP server.
Note:
• You do not need to connect your switcher to a
network for it to function.
3
13