Dhw Heating Once, Outside The Time Program - Viessmann VITODENS Operating Instructions Manual

DHW heating
Time program
(cont.)

DHW heating once, outside the time program

Note
The operating program "Heating and DHW" or "Only
DHW" must be set for at least one system heating cir-
cuit.
Extended menu
1.
2. "Heating"
Setting the time program for the DHW circulation pump
Factory setting: "Automatic"
In other words, the DHW circulation pump operates in
parallel to the DHW heating time program.
Extended menu:
1.
2. "DHW"
Stopping DHW heating
You do not want to heat DHW or provide central
heating
For the preferred heating circuit
Standard menu
1. / for the operating program "Standby mode" (frost
protection is active)
2. OK
For all heating circuits
Extended menu
1.
2. "Heating"
3. / for the required heating circuit if necessary
4. "Heating program"
5. "Standby mode" (frost protection active)
24
3. "Party mode"
4. Deactivate "Party mode" again with "OFF" to pre-
vent unintentional central heating to standard room
temperature.
3. "DHW circ time prog"
4. Set the required time phases.
Procedure for setting a time program, see page 13.
Note
Between time phases the DHW circulation pump
remains off.
You do not want to heat DHW, but do want to pro-
vide central heating
—
Extended menu
1.
2. "Heating"
3. / for the required heating circuit if necessary
4. "Heating program"
5. "Heating and DHW"
6. until the menu is displayed
7. "DHW"
8. "Set DHW temperature"
9. Set 10 °C.