Opening The Control Unit - Viessmann VITODENS Operating Instructions Manual

Opening the control unit

14°C
Fig. 1
Programming unit
You can change any settings on your heating system
centrally at the programming unit of the control unit.
If remote control units are installed in your rooms, you
can also adjust the settings at the remote control units.
Remote control operating instructions
21 °C
14 °C
Fig. 2
This takes you to the previous step in the menu or
cancels a setting that has been started.
Cursor keys
Scroll through the menu or adjust values.
Two control levels are available:
The standard menu: See page 10
■
The extended menu: See page 11
■
"Help" menu
Displays explanations about operation in the form of a
short guide.
21°C
Note
The programming unit can be placed in a wall mount-
ing base. The wall mounting base is available as an
accessory. Ask your heating contractor for more infor-
mation.
OK Confirms your selection or saves the setting.
Calls up "Help" (see following chapter) or addi-
tional information on the selected menu.
Calls up the extended menu.
Note
The screensaver is activated if you have not made
any adjustments on the programming unit for a few
minutes (see page 11).
Call up the short guide as follows:
If the screensaver is active (see page 11):
■
Press .
From anywhere in the menu:
■
Keep pressing until the standard menu is shown
(see page 10).
Press .
Operation
9