Positioner Setup (Diseqc1.2) - Az-Box EVO XS User Manual

EVO XS
Manual

4.2.8. Positioner Setup (DiSEqC1.2)

Positioning" appears on the screen. On the Motor Setting item, using
◄►keys, you need to set DiSEqC 1.2.
To move the antenna, select the desired satellite, transponder, and step size.
Then select Move Dish and press the ◄►keys to move the antenna West or
East. If you selected Continuous for the step size, the antenna will move
continuously until you press another Key. Once the antenna is positioned
properly (maximum level in the quality meter), select Command Mode and
choose save. Press OK to save the position. The position number will then be
displayed next to the satellite name. When you want to move the antenna to a
saved satellite position, select the satellite, choose Go To Position from the
Command Mode and press OK. To clear a saved satellite position, select
satellite, then choose Reset from the Command Mode and press OK.
Setting and enabling East and West limits that the dish can move to is done by
pressing the Blue key for LIMIT SETTING.
East Limit Set:
Move the dish to the most eastern position and press OK to store it.
West Limit Set:
Move the dish to the most western position and press OK to store it.
The East and West Limits are only active if you enable the limits. They are not
active if your Disable the limits.
Note: Limits do not need to be set if you have no obstacles or barriers
preventing your dish from moving the full range of the motor.
This mode will allow you to set the
antenna position for each satellite. In order
to use antenna positioner you must use a
motor controlled by DiSEqC 1.2
commands.
Moving cursor on the Positioner Setup
item in the Antenna Setup submenu and
confirming this selection by pressing OK,
another submenu
24
User's
named "Antenna