EVO XS
Manual
4.2.3. LNB Frequency
•
To scan channels, you must select the correct LNB type that you have on
your dish. The default value is for the Universal LNB. You can change the
LNB Type by using the Left/Right button. Other common LNB types used in
North America are 5150 for C-band LNBs, 10750 for Standard LNBs and
11250 for Circular LNBs.
•
Select the proper LNB type using the ◄►keys according to the LNB type
you are using. All settings for the LNB type are shown below:
Universal (975MHz & 10600 MHz)
o
Standard C-band (5150MHz)
o
Standard Ku-band (10750MHz)
o
Standard Ku-band (11250MHz)
o
Manual entry field (Enter Value) where you can input the L.O. frequency
o
you need using the numeric keys.
22KHz control is set to OFF for each LNB type, but can be turned ON. For
the Universal LNB type, it defaults to AUTO, and cannot be changed.
4.2.4. DiSEqC Switch
•
If a DiSEqC switch is used, select the port number that corresponds to the
output of the DiSEqC switch.
4.2.5. 0/12 V Switch
•
By turning this function On or Off, the receiver will either supply or not
supply 12V from this terminal using ◄►keys.
4.2.6. LNB Power
•
Set the LNB power On/Off by using ◄►keys.
4.2.7. TP Frequency
•
Select a specific transponder by using the ◄►keys, or by pressing the OK
button to view the drop-down list. When the dish is positioned properly to
receive the satellite signal, the Quality bar meter will indicate a signal in a
green color when an active TP is selected. You can add a new TP to the
end of the list by selecting "New TP".
23
User's