Table of Contents
Advertisement
EVO XS
Manual
4.2. INSTALLATION
If it is first time using the receiver, you will need to set the correct parameters for
the system configuration. The installation menu is used to set all the
parameters for the equipment you are using, i.e., preferred satellite, dish/LNB,
DiSEqC switches or dish motors. In this section you will also learn how to use
the various scan options available, and how to edit transponder (TP) and
satellite (SAT) information.
4.2.1. Antenna Setup
The Antenna Setup menu controls all the parameters for your installation.
Ensure that your satellite receiver is correctly connected to your television and
dish, and that your satellite signal is of good quality by checking the Signal
Quality meter. (If you are not sure about this, then ask your installer to check
your installation or satellite signal).
4.2.2. Satellite Name
selected and that satellite's default parameters will appear in the sub-menu.
•
From the satellite's sub-menu, you can adjust the LNB type, LNB Frequency,
DiSEqC switch, 22kHz switch, LNB power, TP, and Positioner Setting, and
search mode. The displayed information can be adjusted for each selected
satellite. When you want to change the satellite, press OK on the Satellite
item cursor and the satellite list will be displayed again. When channels
have been downloaded into the receiver for a particular satellite, a check
mark will appear next to the satellite name. At any time you can press
BACK to go to the previous menu.
•
Select the satellite you want to
program. Scroll through the various
satellites using the ▲▼keys (or
Page Up/Down keys), and select
the appropriate satellite by
pressing OK.
•
When you select the satellite by
pressing OK, the satellite will be
22
User's
Advertisement
Table of Contents
