Wan2 Interface; Mode Settings - D-Link DRO-220i User Manual

DHCP, DNS and Time
This Interface is used for WAN Connectivity through an ISP. The ISP allocates and
provides a static Global IP Address for WAN connectivity. The ISP will also provide
information regarding the Default Gateway IP Address to be used for this connection.
If you have purchased multiple static Global IP Addresses from the ISP, then configure
the first IP Address as the WAN Interface IP Address. And use the rest of your static IP
Addresses for Many-To-Many or One-To-One NAT Configuration.
Select Interface → WAN1 Configure IP Settings for WAN1 Interface as explained
below.
Web UI
Protocol
IP Address
Subnet Mask
Default Gateway
Note:
The default gateway field specified here will be used by Load balancing feature
to route packets through this interface.

2.4 WAN2 Interface

This Interface is used for WAN Connectivity through an ISP.

2.4.1 Mode Settings

This is to configure ISDN in either Leased or Dialup.
Select Interface → WAN2 → Mode Settings to configure ISDN in either Leased or
Dialup as explained below.
Web UI
Leased
Dial-up
Dlink DRO-220i User Guide
IP Settings for WAN1 Interface
Select the sync protocol either cisco HDLC or sync PPP.
Enter the IP address assigned for the WAN interface
Enter the subnet mask for the IP address
Enter the default gateway address (in the same subnet).
Mode Configuration for WAN2 Interface
Click checkbox to configure ISDN in Leased mode.
Click checkbox to configure ISDN in Dial-up mode.
16