Canon iPF750 series Service Manual page 50

Chapter 1
[System Setup] [Sleep Timer]
[Buzzer]
[Contrast Adj.]
[Date & Time]
[Date Format]
[Language]
[Time Zone]
[Length Unit]
[Detect Mismatch]
[Paper Size Basis] [Roll Selection 1]
[Keep Paper Size]
[TrimEdge Reload]
[Rep.P.head Print]
[Nozzle Check]
[Use RemoteUI]
[Reset PaprSetngs]
1-36
Setting Item
[Date]
[Time]
Roll Selection 2
T-1-19
Description/Instructions
Specify the period before the printer enters Sleep mode.
Set the buzzer. Choose On for the buzzer to sound once for warnings and three times for errors.
Adjust the Display Screen contrast level.
Set the current date.
Set the current time. This can be set only when [Date] is set.
Specify the date format.
Specify the language used on the Display Screen.
Specify the time zone. Time zone options indicate a main city in this time zone and the
difference from Greenwich Mean Time.
Choose the unit of measurement when roll length is displayed. You can switch the unit
displayed for the remaining paper amount.
Set the printing behavior when the paper type and size set with the printer menu does not match
the paper type and size set with the printer driver.
Select [Pause] to pause printing. Select [Warning] to print a warning and continue printing.
Select [None] to continue printing without displaying a warning. Select [Hold Job] to queue the
job with different paper type and size in a job queue on the hard disk.
When the size of roll paper is detected, select which roll width to use if the roll width is between
[ISO A3 (297mm)] and [300mm Roll].
When the size of roll paper is detected, select which roll width to use if the roll width is between
[10inch (254mm)] and [JIS B4 (257mm)].
Select [On] to give priority to paper size. If the margin set with the printer driver is less than
the margin set with the printer menu, the margin set with the printer menu has priority and text
and images extending beyond the margins are truncated.
Select [Off] to give priority to margin settings. If the margins set with the printer driver and the
margins set with the printer menu are different, the larger settings are used for printing.
Select whether cut the leading edge of the paper when the paper at the standby position has
loaded. Cut it when the roller trace at the standby position attract attention. Choose On to cut it
everytime when the paper at the standby position has loaded. Choose Automatic to cut it when
the paper at the standby position during two days or more has loaded.
Select [On] to automatically perform [Adjust Detail] after replacing the Printhead.
Set with [Frequency] the timing to check for nozzle clogging after printing. Select [Standard]
to adjust the checking timing according to the nozzle usage.
Select [1 page] to check after each page.
Select [On] for [Warning] to display a warning when the print head nozzle is clogged while
printing.
Select [Off] to disable access from RemoteUI and enable setting only from the operation panel.
Restores settings that you have changed with Media Configuration Tool to the factory default
values.