Canon iPF750 series Service Manual page 49

Setting Item
[Interface [EOP Timer]
Setup]
[TCP/IP] [IPv4]
[IPv6]
[NetWare] [NetWare]
[Frame Type]
[Print Service]
[AppleTalk]
[Ethernet [Auto Detect]
Driver]*12
[Comm.Mode]
[Ethernet Type]
[Spanning Tree]
[MAC Address]
[Interface Print]
[Return Defaults]
T-1-18
Specify the timeout period before cancellation of print jobs that cannot be received by the
printer.
[IPv4 Mode] Choose whether the printer IP address is configured automatically or a static IP address is
entered manually.
[Protocol]- Specify the protocol used to configure the IP address automatically.
[DHCP]/
[BOOTP]/
[RARP]
[IPv4 Specify the printer network information when using a static IP address.
Settings]-[IP Enter the IP address assigned to the printer, as well as the network subnet mask and default
Address]/ gateway.
[Subnet
Mask]/
[Default G/W]
[IPv6 Support] Set whether to support IPv6 connection.
[IPv6 Set whether to use IPv6 stateless address.
StlessAddrs]
[DHCPv6] Set whether to use DHCPv6 setting.
Specify the NetWare protocol. To apply your changes, choose Register Setting.
Specify the frame type to use.
Choose the print service.
Specify whether to use the AppleTalk protocol. To apply your changes, choose Register
Setting.
Specify the communication method. To apply your changes, choose Register Setting.
Choose On for automatic configuration of the LAN communication protocol. Choose Off to use
settings values of Comm.Mode and Ethernet Type.
Choose the LAN communication method.
Choose the LAN transfer rate.
Choose whether spanning-tree packets are supported over the LAN.
Displays the MAC address.
Print the interface settings.
Select [OK] to return the [Interface Setup] settings to factory default.
Description/Instructions
Chapter 1
1-35