Canon iPF750 series Service Manual page 236

Chapter 7
3.4 e-RDS Related Setting Details
1) e-RDS's Operation Mode [E-RDS SWITCH]
In service mode, referring to the "Service Mode Menu Tree", go to [E-RDS SWITCH] menu using
(1) Choose between [ON] or [OFF] using the
(2) Press [OK] key to determine the operation mode and go back to the previous screen.
- When the operation mode is determined, "=" will be displayed.
- OFF:When it is set to [OFF], e-RDS is not used. Default value is OFF.
- ON:When it is set to [ON], e-RDS is used.
2) UGW Address [UGW-ADDRESS] and UGW port [UGW-PORT]
Usually, the default values set in advance are used for the setting value of [UGW-ADDRESS] and [UGW-PORT]. Unless there is a special instruction, the default
value should not be changed. If it should be changed, the communication with UGW may have an error. If [UGW-ADDRESS] and [UGW-PORT] are changed, the
new setting will be enabled after power OFF/ON.
Therefore, usually, the setup is not necessary.
* If you change under a special instruction, perform the following procedure.
(1) Setting address for UGW
- In service mode, referring to the "Service Mode Menu Tree", go to [UGW-ADDRESS] menu using
- Press key to enter the Setup Mode. (A character indicating the input mode (in the upper right corner of the screen) and the cursor are displayed.)
Enter UGW address (URL).
Display to indicate an input mode
A:Alphabet capital letter
a:Alphabet small letter
1:Numerical character
- The cursor is shown at the first letter.
- Use and keys to select characters to enter.
- Press [Back] key to cancel what you entered and go back to the previous screen.
- Press [OK] key to determine what you entered and go back to the previous screen.
(2) Setting up the GW Port Number
- In service mode, referring to the "Service Mode Menu Tree", go to [UGW-PORT] menu using
- Press key to enter the Setup Mode. (A cursor is displayed.)
Enter a port number.
- Use and keys to select characters to enter.
- Press [Back] key to cancel what you entered and go back to the previous screen.
- Press [OK] key to determine what you entered and go back to the previous screen.
* The actual setting value of UGW address [UGW-ADDRESS] and UGW port [UGW-PORT] are categorized as confidential information, so they are not de-
scribed in this manual.
7-28
and keys.
E - R D S S W I T C H
O F F
F-7-21
E - R D S S W I T C H
= O N
F-7-22
E - R D S
U G W A D D R E S S
F-7-23
U G W A D D R E S S
h t t p : / /
F-7-24
E - R D S
U G W P O R T
F-7-25
U G W P O R T
F-7-26
key and key.
key and key.
: a
key and key.
0 0 0 0 0