Resetting Firmware To The Factory Default Version - Extron electronics DisplayPort DP DA2 User Manual

12.
13.
14.

Resetting Firmware to the Factory Default Version

Occasionally the newly installed firmware may conflict with the system. If that occurs, it
will be necessary to restore the original (factory-installed) firmware using the reset button,
which is located in a recess on the base (see figure 14).
Use a small screwdriver to press the reset button for 10 seconds while powering on the
DP DA2. The front panel power LED blinks amber three times, then lights solid amber, and
finally blinks amber three more times while the reset occurs. When the reset is complete,
the power LED lights solid green.
Figure 14.
Firmware Loader Screen with a DP DA2 Added
Figure 13.
If you want to remove a device from the Devices section, do the following:
a. Click the names of the devices to be deleted, to highlight them.
b. Select
Remove Selected Device(s)
c. In the Remove Device(s) window, select or deselect any devices on the list as
desired, then click
Remove
To remove all devices, select
Click . The following indicators show the progress of the update:
Begin
The Transfer Time section shows the amounts of remaining and elapsed time for
•
the update.
The Total Progress section displays a progress bar with
•
In the Devices section, the
•
percentage and another progress bar. The
The upload is complete when the
column shows
Progress 100%
and in the column. Close the Firmware Loader window.
Status
Firmware Reset Button on the Base of the DP DA2
from the
Edit
.
from the
Remove All Devices
column displays an incrementing
Progress
column displays
Status
field shows
Remaining Time
, and is displayed above the progress bar
Completed
DP DA2 • Updating Firmware
menu.
menu.
Edit
above it.
Uploading...
.
Uploading
, the
00.00.00
Reset Button
23