Freemotion 1020 SY User Manual page 11

6. Orient the Weight Guides (29) so that the indi-
cated holes are in the locations shown.
Attach a Weight Guide (29) to the Weight Stack
Base (109) with an M10 x 65mm Bolt (85), two
M10 Washers (93), a 13mm Spacer (86), and an
M10 Locknut (84); do not tighten the Bolt yet.
Attach the other Weight Guide (29) in the
same way.
7. Slide two Round Weight Bumpers (48) onto each
Weight Guide (29). Next, slide fourteen Weights
(30) onto the Weight Guides.
Insert the Weight Selector (28) into the stack of
Weights (30). Make sure that the pin on the
Weight Selector sits in the groove in the top
Weight.
Press the Plastic Bushing (52) into the center
hole in the fifteenth Weight (30). Then, slide the
Weight onto the Weight Guides (29); make sure
that the Plastic Bushing is turned so that one
of the slots slides over the pin on the Weight
Selector (28).
6
29
86
93
85
7
Pin
29
Groove
11
Holes
84
93
29
109
52
Slot
30
28
29
30
48