Page 1
Write the serial number in the space above for future reference. Serial Number Decal (inside tower) QUESTIONS? At FreeMotion Fitness, we are committed to providing com- plete customer satisfaction. If you have questions, see HOW TO CONTACT CUSTOMER CARE on the back cover of this manual.
35 or persons with pre-existing health problems. Read all instructions before using. FreeMotion Fitness assumes no responsibility for personal injury or property damage sustained by or through the use of this product.
WARNING DECAL PLACEMENT The decals shown below have been placed on the strength equipment in the indicated locations. If a decal is missing or illegible, see HOW TO CONTACT CUSTOMER CARE on the back cover of this manual and order a free replacement decal. Apply the decal in the location shown. Note: The decals may not be shown at actual size.
GZFI8033.6. The serial number can be found reliable product for your club. And the advanced solu- on a decal attached to the strength equipment (see the tions to isolating individual muscle groups make the front cover of this manual).
ADJUSTMENT This section explains how to adjust the strength equipment. Make sure all parts are properly tightened each time the strength equipment is used. Replace any worn parts immediately. ADJUSTING THE RESISTANCE To change the amount of resistance for your workout, insert the weight pin into the desired weight.
Page 7
ADJUSTING THE THIGH PADS Sit on the seat with your legs under the thigh pads. Pull the tapered pop pin out and move the thigh pads so that they press firmly onto your lower thighs. Pop Pin Reengage the pop pin. Seat Thigh Pads...
Personnel must also record and report any accident. To maintain the strength equipment’s warran- ty, use only FREEMOTION EPIC parts for repair or replacement. If there are any questions or concerns, see HOW TO CONTACT CUSTOMER CARE on the back cover of this manual.
Page 9
Cable Guards repetition is begun. Ideally, the cable should not move Check the cable guards to ensure that they are not more than 1/2 in. (1.5 cm) from the resting position rubbing against the cables and that they are holding before the top weight is lifted.
Page 10
Top Weight Adjustment 3. Pull the cable out of the top weight coupler. Tools required: 5/32” hex key Determine the amount that the cable needs to be shortened, and cut that much off the end of the 1. If the cable needs to be shortened 3/4 in. (2 cm) cable.
Page 11
WEIGHT STACK SERVICING 8. Replace the top weight. Next, tighten the rod nut, rod star washer, and rod washer onto the weight Servicing the weight stack involves replacing the two rod. guide bushings and weight insert in the top weight. To order these parts, see HOW TO CONTACT CUS- 9.
CABLE DIAGRAM The cable diagram shows the proper route of the cable. Use the diagram to make sure that the cable and the cable guards have been assembled correctly. If the cable has not been correctly routed, the strength equipment will not function properly and damage may occur.
PART LIST—Model No. GZFI8033.6 R1106A If replacement parts are needed, or if parts are missing or damaged, see HOW TO CONTACT CUSTOMER CARE on the back cover of this manual. Key No. Qty. Description Key No. Qty. Description Base Pivot Leg...