Table of Contents
Advertisement
CB40
Checking Drive Unit Oil
1
Check gear lube monitor oil level; keep oil level at or near "Fill"
line. Check for water at bottom of monitor and/or if oil appears a milk-
tan, contact your Authorized MerCruiser Dealer immediately; both
conditions indicate a water leak somewhere in the drive unit. See
"Filling Reservoir."
IMPORTANT: If more than 2 fl. oz. (59ml) of Quicksilver High
Performance Gear Lube is required to fill monitor, a seal may be
leaking. Damage to drive unit may occur due to lack of lubrica-
tion. Contact your Authorized MerCruiser Dealer for service.
CB41
Checking Power Trim Pump Fluid
Place drive unit in full down/in position.
2
Remove fill cap from reservoir and observe oil level. Level must
be up to, but not over bottom of filler neck. Add Quicksilver Power
Trim and Steering Fluid or SAE 10W-30 motor oil, if required, to bring
level to bottom of filler neck. Replace cap.
A Check that "Cap plug" has been removed and discarded from
filler neck.
B Fill cap is vented; frequently check that vent is open and unre-
stricted.
Alpha V8
63
Advertisement
Table of Contents
