Table of Contents
Advertisement
CA114
Loosen hose clamps and remove the following hoses:
5
From seawater pickup pump inlet.
6
From power steering fluid cooler.
7
Crank engine over slightly with starter motor to purge any water
trapped in seawater pickup pump. DO NOT allow engine to start.
8
Make sure gear housing water drain holes and speedometer pitot
hole are open and unobstructed.
After seawater section of cooling system has been drained com-
pletely, coat threads of drain plugs with Quicksilver Perfect Seal and
reinstall. Reconnect hoses and tighten all hose clamps securely.
After draining perform all checks inspections, lubrication and fluid
changes outlined in MAINTENANCE CHART under AT LEAST
ONCE A YEAR.
Store boat with drive unit in full "down" position.
Alpha V8
103
Advertisement
Table of Contents
