Precor TRM 800 Series Assembling And Maintaining Manual page 51

Installing the Console
After the console has been seated, separate the individual
cables out of the end of the console cable assembly and
attach them to the appropriate circuit connectors inside the
console. Refer to the following diagram and table to identify
the cables and connectors.
Important: All cables must pass through the opening in the
center of the console mount.
Figure 28: Cable connections, P30 and P10 consoles
Table 3. P30 and P10 internal cable connections
Cable
Safety key (treadmills
only)
Data from base unit
Heart rate sensors
CSAFE
Connector Type
Six-contact strip, keyed
Eight-contact modular,
on flat gray cable
Four-contact strip, keyed
Eight-contact modular,
on flat gray cable
49
Circuit Connector
Location