Precor TRM 800 Series Assembling And Maintaining Manual page 26

24
3. Feed the data cable from the treadmill drive unit through
4. Place the upright support on your left onto its base frame
5. Secure the upright support to the side bracket using three
6. Pull the data cable gently upward through the upright
7. Place the remaining upright support over the base frame
Assembling and Maintaining TRM 800-Series Treadmills
the cable channel in the upright support on your left, from
bottom to top.
side bracket, making sure that the rounded edge of the
upright support faces you.
³ ₈-inch × 1-inch buttonhead screws and three ³ ₈-inch
narrow flat washers. Partially tighten the fasteners using a
⁷ ₃₂-inch hex wrench.
Figure 5: Upright support attachment
support to remove any extra cable from the base of the
treadmill. Drape the upper end of the data cable over the
inside edge of the upright support, using tape to hold it in
place if necessary.
side bracket on your right so that the rounded edge of the
upright support faces you. Secure the upright support to
the side bracket using four ³ ₈-inch × 1-inch buttonhead
screws, then partially tighten the fasteners using a
⁷ ₃₂-inch hex wrench.