Brady BMP 21-PLUS User Manual page 87

Problem
Program
Invalid terminal repeat value
entered.
Error - "Cannot Fit"
Error - "Cannot Fit"
Error - "Cannot Fit"
Left and right justification not
working.
Text not centered on label.
A large section of blank label prints
after text.
Cannot change location of the
human readable text in a barcode.
Cause
The value entered is out of the
range.
Font size and settings too large for
label.
There are too many lines of text.
The maximum number of lines
allowed is four.
Wrong label type or orientation
The BMP21-PLUS/
BMP21-LAB
printer currently does not support
left or right justification. All label
text will be center justified only.
Possible blank spaces added to text. Press Clear
Possible blank lines added after
text.
The human readable text is
automatically added below the
label. This position is fixed and
cannot be changed.
Troubleshooting
Corrective Action
The acceptable range is between
the minimum of 0.2 inch to the
maximum of 40 inches.
• Change the font size to a smaller
font. (Refer to page
• Delete some text.
(See page 37 for more
information.)
A blank line is considered another
line of text. DO NOT press ENTER
at the end of a line if you DO NOT
want another line. (See
• Select a different label type (e.g.,
banner landscape). (See
page 55.)
• Change orientation (vertical or
horizontal). (See page
No action required.
re-enter text.
Press Clear
re-enter text.
No action required.
BMP ® 21-PLUS/BMP ® 21-LAB User's Manual
75
37.)
page 35.)
48.)
, then
, then