If serialization is turned OFF, continue with the following:
Navigate to the # of Terminations: (or # of Ports:) field and enter the number of terminals
3.
or ports needed.
Navigate to the Rotation: field (not visible on the initial data fields screen), and determine
4.
if you want the label data to print out at 0
rotation (portrait). Use the left or right navigation key to switch between degrees of
rotation.
Landscape printout - rotation 0
When finished, press Enter
5.
If serialization was turned OFF, proceed to Step 13. If serialization was turned ON, you are
presented with the Serial screen. Continue with the following:
With the cursor displayed in the Start: field, enter the start value of the sequence.
6.
In the Increment field, enter the increment value.
7.
The default increment is 1. If that is the desired increment, skip this entry field.
In the End: field, enter the end value of the sequence.
8.
When ready, press Enter
9.
If serialization was turned ON, the serial start value is displayed on the editing screen.
However, all labels in the serial sequence will print out. Likewise, if you delete the start value
on the editing screen, the entire serialization sequence will be deleted.
Terminal Block, Patch Panel (BMP
°
rotation (landscape) or print vertically at 90
°
Portrait printout - rotation 90
.
.
BMP ® 21-PLUS/BMP ® 21-LAB User's Manual
63
®
21-PLUS only)
°
°