Table of Contents
Advertisement
Available languages
Available languages
Features
Front Panel
2
7
1
1
3
3
4
4
5.25"
(13.3cm)
5
5
6
6
8
8
1.
Trim: Sets the channel's input level. Adjust this so that the Peak LED lights on the
loudest passages and then back it down so it no longer peaks.
2.
Peak LED: The LED will flash if the signal is "clipping." If this happens, decrease the
setting of the Gain knob or Channel Fader.
Note: Avoid amplifier "clipping" at all costs. Clipping occurs when the power amplifier is
distorting and working beyond its limits. Amplifier distortion is the major cause of speaker
failure.
3.
Hi EQ: Provides up to 15 dB of boost or cut to the 12 KHz frequency range.
4.
Lo EQ: Provides up to 15 dB of boost or cut to the 80 Hz frequency range.
5.
Aux 1: Sends the channel's signal to auxiliary processors, onstage monitors, or
headphone amplifiers. Aux 1 is pre-fader, meaning it takes the signal before the channel
fader position. This is ideal for sending a signal to monitors or headphone amplifiers.
6.
Aux 2: Sends the channel's signal to auxiliary processors, onstage monitors, or
headphone amplifiers. Aux 2 is post-fader, meaning it takes the signal after the channel
fader position. This is ideal for sending a signal to outboard processors.
7.
Channel Fader: Controls the signal level of the Mic and Line inputs.
8.
Pan/Bal: Directs the output signal to the left or right Main Out. Pan controls are found on
mono channels, sending the mono source to either the left or the right speakers or
anywhere in between. The Bal controls are found on stereo channels which take a stereo
source and varies the relative level of the channels, so that the left channel will not come
out of the right speaker when adjusting the Bal control fully right and vice-versa.
9.
Ext In: 1/8" (3.5mm) stereo line level input for Channels 9 and 10.
10. Ext Out: 1/8" (3.5mm) stereo output that mirrors the Main Outputs.
11. Mic Input 1/2: XLR-1/4" (6.35mm) combo inputs for use with dynamic and condenser
mics. The signal level is controlled with Channel Faders 1 and 2, respectively. When
front panel Mic Inputs 1 and 2 are in use, this will disable the rear panel Mic Inputs 1
and 2.
12. Power LED: Indicates whether DN-410X is powered on or off.
13. Phantom Power LED: Indicates whether the phantom power is enabled for the Mic
Inputs.
14. Pair/Unpair: Press this button to pair a Bluetooth device or to disconnect a paired
Bluetooth device. DN-410X has a transmission range up to 100 feet (30.5 meters).
2
2
2
7
7
7
1
1
3
3
4
4
5
5
6
6
8
8
2
2
7
7
7
1
1
1
3
3
3
4
4
4
5
5
5
6
6
6
8
8
8
19" (48.3 cm)
2
12 13 14
9
10
17
11
16
11
15
18
19
20
5
- Quick Links:
- User Guide
Hide quick links:
Advertisement
Table of Contents
