Weekly Maintenance - Tennant 1610 Operator's Manual

OPERATION
4. ReadySpace Cleaning: Remove the splash shroud
and inspect the rollers for wear. If the gap between
the two rollers is greater than 4mm (5/32") replace
the rollers (Figure 27). Always replace rollers as
a set.
Splash
Shroud
FIG. 27
5. Clean the machine housing with an all purpose
cleaner and damp cloth (Figure 28).
FOR SAFETY: When servicing machine, do not
power spray or hose off machine. Electrical
malfunction may occur.
FIG. 28
6. Recharge the batteries (Figure 29). See
CHARGING BATTERIES.
NOTE: To prolong the battery life, ONLY recharge the
batteries after a total of 30 minutes of use or more.
FIG. 29
18
GAP
Replace rollers
if gap is greater
than shown.
Home Find... Go To..

WEEKLY MAINTENANCE

(Every 10 Hours of Use)
1. Flip the ReadySpace rollers end-for-end every 10
hours of use (Figure 30). The roller life is rated for
at least 100 hours of use under normal cleaning
conditions. If the gap between the two rollers is
greater than 4mm (5/32") replace the rollers.
FIG. 30
2. Remove any debris build--up from the underside of
the scrub head (Figure 31).
FIG. 31
3. Remove the front and rear roller vacuum shoe
covers and remove any debris (Figure 32).
FIG. 32
4. Remove any entangled carpet fibers and debris
from the brushes (Figure 33). Replace brushes if
worn. To determine when to replace worn brushes
observe the brush pressure meter.
Tennant 1610 (04- -07)