Do not unplug by pulling on cord. Do not stretch cord. Do not handle plug with wet hands. Keep cord away from heated surfaces. Report machine damage or faulty operation immediately. Follow mixing and handling instructions on chemical containers. Tennant 1200 (04-01) Home Find... Go To..
The plug must be plugged into an appropriate outlet that is properly installed in accordance with all local codes and ordinances. Grounded Outlet Grounding Edge/hole Home Find... Go To.. Tennant 1200 (04-01)
– WARNING: Flammable materials can cause an explosion or fire. Do not use flammable materials in tank(s). Flammable materials or reactive met als can cause explosion or fire. Do not pick up. Home Find... Go To.. Tennant 1200 (04-01)
9. Recovery Tank Cover 10. Recovery Sight Window 11. Recovery Tank 12. Solution tank 13. Floating Brush Base 14. Pick-Up Head 15. Accessory Tool Solution Hose Coupler 16. Accessory Tool Vacuum Hose Port FIG. 2 Tennant 1200 (04-01) Home Find... Go To..
Page 8
(Figure 4). Grounded Outlet Grounding Edge/hole FIG. 3 FIG. 4 FOR SAFETY: Do not operate machine unless cord is properly grounded. FOR SAFETY: Do not operate machine with the use of an extension cord. Home Find... Go To.. Tennant 1200 (04-01)
3. Release triggers at end of path and continue to pull machine to pick up excess solution. CLEANING CARPETS 1. Turn main power switch on (Figure 5). 4. Tip machine back on wheels and push machine forward to begin next path. FIG. 5 Home Find... Go To.. Tennant 1200 (04-01)
4. If brush stops, the circuit breaker may have been tripped. Unplug power cord, check brush for obstruction. Push brush reset button to resume (Figure 7). FIG. 8 FIG. 7 Tennant 1200 (04-01) Home Find... Go To..
NOTE: Make sure to rinse out recovery tank before refilling solution tank. FIG. 10 4. After cleaning, relieve water pressure from tool before disconnecting hose. Squeeze trigger for five seconds after turning main power switch off. Home Find... Go To.. Tennant 1200 (04-01)
1. Empty and rinse out recovery tank thoroughly FIG. 12 (Figure 13). 2. Replace drain hose. FIG. 13 2. Remove float shut-off screen from recovery tank cover and clean (Figure 14). FIG. 14 Home Find... Go To.. Tennant 1200 (04-01)
Page 13
Coil cord neatly after use. 5. Remove any entangled carpet fibers and debris from brush (Figure 16). 8. Clean machine with an all purpose cleaner and damp cloth (Figure 18). FIG. 16 FIG. 18 Home Find... Go To.. Tennant 1200 (04-01)
Next day, spray out remaining solution and flush system with 11L (3 gal) of clean water. 2. Lubricate wheels with a water resistant oil. 3. Inspect machine for water leaks and loose hardware. loose Home Find... Go To.. Tennant 1200 (04-01)
3. Open recovery tank cover to promote air circulation. ATTENTION: Do not expose to rain. Store indoors. ATTENTION: If storing machine in freezing temperatures, be sure that machine and solution system are completely drained and dry. Home Find... Go To.. Tennant 1200 (04-01)
Replace spray tips. Solution tank low or empty. Refill solution tank. Faulty solution pump. Contact Service Center. Pump needs priming. Prime pump by pressing solution hose coupler tip located at front of machine. Home Find... Go To.. Tennant 1200 (04-01)
Page 17
OPERATION Home Find... Go To.. Tennant 1200 (04-01)