3 Device Installation
Important
Please make sure the installation surface can support a minimum of 3 times the weight of the camera.
Figure 3-1 Device installation 1
Please see Figure 3-1 and Figure 3-2.
Step 1
Put installation template on the designated surface where you will install the device (wall or ceiling).
Step 2
Drill holes according to position of the holes on the installation template.
Step 3
Open accessories bag, take out the expansion bolts and insert them into the drilled holes.
Step 4
Take out the screws. Tighten the 4 screws to fix the device on the installation surface (wall or ceiling). The sun
shield can be adjusted. Tighten the screws on the sun shield when finished.
Step 5
Connect all applicable wiring properly.
5