Device Installation - Speco O4D1 Quick Start Manual

2 Device Installation

2.1 Installation Steps
Note:
Before installation, please make sure the installation surface can support a minimum of 3
times the weight of the camera
Step 1
Use inner hex wrench in the accessories bag to open dome enclosure by unfastening three inner
hex screws on enclosure.
Step 2
Put installation template on the designated surface where you will install the device (wall or
ceiling).
Step 3
Drill holes according to position of the holes on the installation template and then insert the
expansion bolts in the holes. Secure these three bolts firmly.
Note:
If user pulls out cable from top of installation surface, you must dig an exit hole on
installation surface according to the installation template.
If user pulls out cable from side of cable channel, it must go through the U-shape channel on
dome pedestal, and take out cable from the side exit hole on pedestal.
Step 4
Figure 2-1 Device installation illustration
5