How To Assemble Your Ceiling Fan - Fanimation Stonehill FP7953CH Owner's Manual

1. Remove the hanger ball
hanger ball assembly by loosening the set screw in the
hanger ball until the ball falls freely down the downrod.
Remove the pin from the downrod, then remove the
hanger ball. Retain the pin and hanger ball for reinstal-
lation in Step 7. (Figure 1)
2. Remove the hairpin clip and clevis pin from the
bottom of downrod. Retain the pin and clip for
3. Loosen the two set screws in the downrod support
of the motor assembly. Route the black, white and blue
wires through the downrod. (Figure 3)
4. Slide downrod into the downrod support on top of
the motor. Install the clevis pin by aligning the holes
in the downrod support with holes in the downrod.
Secure clevis pin with hairpin clip. Tighten the two set
screws with nuts in the downrod support. (Figure 4)
WARNING
It is critical that the clevis pin in the downrod support
is properly installed and the set screws and nuts are
securely tightened. Failure to do so could result in
the fan falling.
5. Route wires through the motor coupling cover and
assemble the coupler to the motor assembly using the

How to Assemble Your Ceiling Fan

portion from the downrod/
Downrod
Set Screw
Hairpin
Clip
Hairpin Clip
3/16 -24 x 3/8
Pan Head Screw
with Lock Washer
Motor
Assembly
HARDWARE USED:
3/16 -24 x 3/8
SCREWS
6
Pin
Hanger Ball
Figure 1
Clevis Pin
Figure 2
Black, White and
Blue Leads
Downrod
Figure 3
Downrod
Set Screws and
Figure 4
Motor Coupling
Cover
Figure 5
x 3