Unpacking Instructions - Fanimation Stonehill FP7953CH Owner's Manual

This manual is designed to make it as easy as possible for you
to assemble, install, operate, and maintain your ceiling fan
Tools Needed for Assembly
blade screwdriver
▲WARNING
Before assembling your ceiling fan, refer to section on
proper method of wiring your fan (page 4). If you feel you
do not have enough wiring knowledge or experience,
have your fan installed by a licensed electrician.
For your convenience, check-off each step. As each step is completed, place a check mark. This will ensure that all
steps have been completed and will be helpful in nding your place should you be interrupted.
▲WARNING
Do not install or use fan if any part is damaged or
missing. This product is designed to use only those
parts supplied with this product and/or any accessories
designated specifically for use with this product by
Fanimation. Substitution of parts or accessories not
designated for use with this product by Fanimation could
result in personal injury or property damage. Contact
your retail store for missing or damaged parts.
1. Check to see that you have received the following
parts:
NOTE: If you are uncertain of part description, refer to
exploded view illustration. (Figure 1, page 16)
Hanger Bracket
Assembly
Ceiling Canopy
Downrod/Hanger Ball
Assembly
Three wire connectors
(supplied)

Unpacking Instructions

Canopy Screw Cover
Assembly
Motor Coupling Cover
Assembly
Fan Motor
Assembly
Wiring outlet box and box connectors must be of type
required by local code. The minimum wire would be a 3-
conductor (2-wire with ground) of the following size:
Installed Wire Length
Up to 50 ft.
50 - 100 ft.
NOTE: Place the parts from the loose parts bags in a small
container to keep them from being lost. If any parts are missing,
contact your local retailer.
Fan Motor Assembly
Hanger Bracket Assembly
Downrod/Hanger Ball Assembly
Ceiling Canopy
Canopy Screw Cover Assembly
Motor Coupling Cover
Adapter-Switch Housing
Light Kit Assembly
Blade Holder Set
Blade Set
Glass
Light Bulbs (3)
Receiver Unit
TR24 Hand-Held Remote
Adapter-Switch Housing
Light kit Assembly
Blade Holder Set Hand-Held Remote
4
Materials
Wire Size A.W.G.
Screws with lock washers
(blade holder to motor)
– Sixteen #8-32 x 8 mm
Washer Head Screw
– Sixteen Ø4.8 x Ø15.5 x 1 mm
Fiber Washer
(blade to blade holder)
– Four
Screw with Lock washer
– L Screwdriver
– Balance Kit
– Four wire connectors
Glass
Light Bulbs (3)
Receiver
Unit
TR24
Hardware Bag
14
12
Blade Set