Troubleshooting Table - Oki OKIPAGE 10e Maintenance Manual

4. TROUBLESHOOTING
4.1

Troubleshooting Table

(A) Power Supply Board (OL1- or OL2-PCB)
Note: Activate the Status Monitor to refer to the window displayed.
Identify the type of the failure.
When all the LEDs of the printer are flashing, you can identify the type by pressing the
switch, which changes the condition of LED illumination.
Flash1 : Slow Blinking
Flash2 : Nomal Blinking
Flash3 : Fast Blinking
Paper input jam occurs frequently.
#: TRAY1, TRAY2, FEEDER, MANUAL
Paper feed jam occurs frequently.
#: TRAY1, TRAY2, FEEDER
Paper-exit jam occurs frequently.
#: TRAY1, TRAY2, FEEDER, MANUAL
Paper size error occurs frequently.
#: TRAY1, TRAY2, FEEDER, MANUAL
The message "# Paper out" remains
displayed on the Status Monitor.
#: TRAY1, TRAY2, FEEDER
The message "Printer Cover open" remains
displayed on the Status Monitor.
The message "Toner Low" remains
displayed on the Status Monitor.
The message "Toner sensor problem" remains
displayed on the Status Monitor.
Thermistor open error.
Thermistor short error.
Serial interface does not connect to the host
device.
41266201TH Rev.1
Failure
# : Standard tray
Second tray
Multi purpose feeder
LED Message
Status Monitor
Ready Manual
VALYD OFF OFF
VALYD OFF OFF
VALYD OFF OFF
OFF OFF
VALYD
VALYD OFF OFF
OFF OFF
VALYD
VALYD UnKnown UnKnown
INVALYD Flash3 Flash3
VALYD UnKnown UnKnown
Flash3 Flash3
INVALYD
Flash3 Flash3
INVALYD
INVALYD
Flowchart
Error
No.
Flash2 A - 1
Flash2 A - 2
Flash2
A - 3
Flash2
A - 4
Flash2 A - 5
Flash2 A - 6
Flash2 A - 7
or
Flash3
(Note 1)
OFF
A - 8
Flash3
A - 9
(Note 1)
Flash3
A - 9
(Note 1)
A - 10
36 /