Conventions; Quality And Warranty - Xtender XTS 900-12 User Manual

Studer Innotec SA
Xtender
2.2 C
ONVENTIONS
This symbol is used to indicate the presence of a dangerous voltage that is sufficient to
constitute a risk of electric shock.
This symbol is used to indicate a risk of material damage.
This symbol is used to indicate information that is important or which serves to optimise your
system.
This symbol placed on the product indicates that its surfaces may reach temperatures
higher than 60°C.
This symbol placed on the product indicates that its use must follow the instructions in the
user's manual.
All values mentioned hereafter, followed by a parameter number indicate that this value may be
modified using the RCC-02/-03 remote control.
In general, the default values are not mentioned and are replaced by a parameter number in the
following format: {xxxx}. The default values for this parameter are specified in the defaults parameter
table, p. 47.
All parameter values modified by the operator or installer must be transferred into the same
table. If a parameter not appearing in the list (advanced parameters) has been modified
by an authorised person with technical knowledge, they will indicate the number of the
modified parameter(s), the specifications of the parameter(s) and the new value set, at the
end of the same table.
All figures and letters indicated in brackets or in square brackets refer to items that can be found in
the separate manual "Appendix to the installation and operating instructions" supplied with the
device. In this appendix, these figures and letters are encircled.
 The figures in brackets refer to elements belonging to the Xtender.
 The uppercase letters in brackets refer to AC cabling elements.
 The lowercase letters in brackets refer to battery cabling elements.
 The comments on figures and items of the appendix are given starting on p. 42.
2.3 Q
UALITY AND WARRANTY
During the production and assembly of the Xtender, each unit undergoes several checks and tests.
These are carried out with strict adherence to the established procedures. Each Xtender has a serial
number allowing complete follow-up on the checks, according to the particular data for each
device. For this reason it is very important never to remove the type plate (appendix 1 – fig. 3b) which
shows the serial number. The manufacture, assembly and tests for each Xtender are carried out in
their entirety by our factory in Sion (CH). The warranty for this equipment depends upon the strict
application of the instructions appearing in this manual.
User manual V4.6.0 6