Fastening Of The Xth Model; Fastening Of The Xtm Model; Fastening Of The Xts Model - Xtender XTS 900-12 User Manual

Studer Innotec SA
Xtender

3.5.1 Fastening of the XTH model

First fix the mounting bracket (26) supplied with the device using 2 Ø < 6-8 mm >screws**.
Then hang the Xtender on the bracket. Fasten the unit permanently using 2 Ø <6-8 mm> screws** on
to the two notches located at the underside of the case.
Dimensions of the appliances are given on Fig 2a of the appendix 1.
A distance of at least 20 cm in between and/or around the XTH devices is required in order
to guarantee sufficient ventilation.

3.5.2 Fastening of the XTM model

First fasten the top screw (6-8mm **) without washer on a solid wall (concrete or metallic wall) up to
a distance of 2mm between head and wall. Hang the device from the screw. If deemed necessary,
the upper support screw can be fully tightened after hanging the device. In theory, this is only
necessary in mobile applications. To access the upper support screw to fully tighten it, remove the
upper plastic grate (see 27 fig. 2a of the appendix).
Dismount the lower plastic grate of the device giving access to the wiring compartment. Carefully
fix the device with two screws (Ø 6-8 mm) in the two holes located at the bottom left and right of the
wiring compartment.
If the Xtender is installed in a closed cabinet this must have sufficient ventilation to guarantee an
ambient temperature that conforms to the operation of the Xtender.
**: These items are not delivered with the device.
It is imperative to ensure complete and safe fastening of the device. A device that is simply
hung may detach and cause severe damage.

3.5.3 Fastening of the XTS model

The XTS enclosure must be first mounted on the support plate with
the 4 screws and washer delivered with the appliance according
with figure aside. Then the unit can be fixed on a heavy-duty
support (concrete or metallic wall) and positioned vertically with
cable glands oriented down. An external ventilation unit (ECF-01,
p. 37) can be installed on top of the unit before or after wall
mounting.
The envelope of the XTS can reach temperatures higher
than 60°C when used for a long period near its max
power level. These high temperatures may remain
present during several tens of minutes after stopping the
unit. It is recommended to choose a place of installation
in a restricted access area, away from children or any
unauthorized person.
User manual V4.6.0 10