Control; Main On/Off Control; Display And Control Panel - Xtender XTS 900-12 User Manual

11 CONTROL

11.1 M /
AIN ON OFF CONTROL
This switch (1) interrupts the electronic supply and
all the Xtender peripherals.
consumption on the battery is therefore less than
1 mA.
The ON/OFF switch is used only for the complete
stoppage of the whole system. This switch is not
available in the XTM. The function can be added
with the use of the remote command module
RCM-10.
11.2 D
ISPLAY AND CONTROL PANEL
The Xtender has an ON/OFF button and light
indicators at the front of the unit, allowing clear
identification of the operating mode.
(41) The ON/OFF button allows the start-up or
complete stop of the system. In the systems
comprising several units, each unit is started or
stopped individually. For a simultaneous start-up of all
the units use the dry contact control (see sect. 7.7 –
p. 32) or the ON/OFF button of the RCC-02/-03
remote control.
Even when the equipment has stopped,
dangerous voltages may be present at the
Xtender input.
(42) This indicator lights up when the equipment has been stopped manually using the ON/OFF
button (41) or due to a fault.
The table below describes the type of fault according to the number of flashes on the indicator (42).
User manual
The residual
V4.6.0
XTS
XTH et XTM
Studer Innotec SA
Xtender
39