Accessories; Remote Control Rcc-02/-03 - Xtender XTS 900-12 User Manual

9

ACCESSORIES

9.1 R
EMOTE CONTROL
An RCC-02/-03 remote control, display and programming unit can be connected to the Xtender via
one of the two RJ45-8-type "Com. Bus" (3) connectors.
Only Studer CAN compatible accessories and devices (mentioned in chapters 9 and 10)
can be connected to the RJ45-8 connectors, excluding any other connections such as LAN,
Ethernet, ISDN or other.
Connecting a non-compatible device may cause serious damage not covered by the
manufacturer's warranty.
These connectors may only be used for connecting a CAN-ST compatible accessory, excluding any
other connection such as LAN, Ethernet, ISDN, etc.
The RCC-02/-03 control centre is vital for modifying the parameters of the system. Many parameters
and features are not described in this manual. The manual for the RCC-01/03 (downloadable on
www.studer-innotec.com) describes in detail each of these parameters and the context in which
they can be used.
It also allows the following functions:
 Display of function synopsis
 Display of the measured operational values (current / voltage / power output, etc.)
 Updating of software or implementation of customised software
 Upload/download of inverter parameter
 Updating of inverter parameters
 Events logging of error message
 Data acquisition of Xtender and other participants connected to the communication bus
like the BSP (Battery status processor) or / and compatible solar charge controller
RCC-02
The features of the RCC-02 and the RCC-03 are the same. They only differ in their external
appearance. The RCC-02 is designed for wall mounting, whereas the RCC-03 is designed as a board
device.
The RCC-03 model must be removed from the board to allow access to the SD card slot (during
updating, for example).
Model N°: RCC-02: Dimensions: H x W x D / / 170 x 168 x 43.5mm
RCC-03: Dimensions: H x W x D / / 130 x 120 x 42.2mm
The two remote control models are delivered with a 2 m cable.
Cables of specific lengths (5 m, 20 m and 50 m) can be ordered.
The article no. is as follows: CAB-RJ45-xx. The length in metres is specified as xx.
User manual
RCC-02/-03
V4.6.0
Studer Innotec SA
RCC-03
Xtender
35