Data - 6Tg2Am - Perkins 415GM Installation Manual

N38143
Data - 6TG2AM
Basic Technical Data
Prime power ........................................92.5kW (124 hp) .......................99kW (133 hp)
Number of cylinders.................................................................6
Cylinder arrangement ..........................................................In-line
Cycle.................................................................................. 4 stroke
lnduction system ............................................................Turbocharged
Bore ............................................................................. 100mm (3.937")
Stroke ........................................................................... 127mm (5.00")
Compression ratio ................................................................ 16:1
Cubic capacity ......................................................... 5.99 litres (365.0 in
Valves per cylinder ..................................................................2
Direction of rotation .......................................Anti-clockwise viewed on flywheel
Firing order ....................................................................1, 5, 3, 6, 2, 4
Total weight (wet).....................626 kg (1380 lbs) engine only including starter and generator.
Cooling System
The coolant shown below is mandatory for use in all climates to ensure that adequate levels of corrosion
inhibitor are present. It will give frost protection to -37
Coolant .............50% inhibited ethylene glycol or 50% inhibited propylene glycol with 50% fresh clean water
Fresh water flow ...............................................123 l/min (32.5 US galls/min)
Coolant pump speed and method of drive................... 1:1 Gear driven
System capacity ..................................................... 24 litres (6.3 US galls)
Pressure cap setting ......................................................50 kPa (7 psi)
Protection switch setting ................................................ 96
Sea water pump type..........................Jabsco gear driven model 25.4mm (1") full cam.
Sea water suggested inlet hose diameter...................... 32mm (1.25")
Sea cock ....................................... Full flow 25.4mm (1.00") max lift of seawater pump 2m
.................................................. Full flow 38.1mm (1.25") max lift of seawater pump 4m
Strainer ............................. A raw water strainer must be included in the suction side of the circuit.
Maximum sea water temperature. ................................. 38
Sea water flow ....................................................71 l/min (18.8 US galls/min)
Fuel System
Recommended fuel specifications. ........BS2869 Class A2 ASTM D 975 Number 2D.
Cetane number ............................................................... 45 minimum
Fuel injection pump .......................Stanadyne rotary and electric stop. (Energised to run).
Fuel lift pump ............................................................. AC Delco type LU
Delivery/hour ............................... 122 l/hr (32 US galls/min ....... 134 l/hr (35 US galls/min)
Pressure .....................................................................30 kPa (4.4 PSI)
1500 rev/min ..........................1800 rev/min
C (-34.6
O
C (205
O
C (100
O
)
3
F).
O
150 l/min (40 US galls/min)
F)
O
F)
O
91 l/min (24 US galls/min)
Data
Page 85