Table of Contents
Advertisement
Comfort controls
To cancel a code entry, turn the TUNE/SOUND switch
while the code entry window is displayed.
The code entry will be cancelled and then the setting
menu will be switched.
To change the lock cancellation code
You can change the code for unlocking channel(s) to any num-
ber you want.
1. Press the TUNE/SOUND switch for about 2 seconds or
longer to enter the MENU mode. Then select the LOCK
setting mode.
2. In the LOCK setting mode, turn the TUNE/SOUND
switch and select "CODE EDIT".
3. When you press the TUNE/SOUND switch, the code
entry window will be shown in the display.
4. Use the memory select buttons to enter the current code
and then press the TUNE/SOUND switch.
5. If the correct code is entered, the code entry window will
be shown again. Enter your desired code.
5
If the entered code is incorrect, a warning sound will be
emitted and "CODE ERROR" will be displayed. The code
entry window will then be shown again.
You can try to enter the code again, no matter how many
times an incorrect code has been entered.
6. After you enter the new code, press the TUNE/SOUND
switch. The code entry window will be shown again for
confirmation. Enter the new code again and press the
TUNE/SOUND switch.
7. "STORED" will be displayed for 2 seconds, the code will
be changed and the satellite radio will return to the LOCK
setting mode.
5-62
NOTE
The SKIP settings, LOCK settings and lock cancellation
code are stored in memory. Disconnecting the battery
cable will erase these settings.
(The lock cancellation code will reset to the default fac-
tory setting: "1111").
To reset the lock cancellation code
In case you forget the code, it is possible to reset the code to the
factory setting (1111).
1. With the audio power OFF, press the PWR switch and the
TUNE/SOUND switch at the same time.
The display will show "CODE INITIAL".
2. Press the TUNE/SOUND switch. "YES" will be dis-
played. To reset the code, press the TUNE/SOUND
switch again. "STORED" will be shown for 2 seconds and
the code will be reset.
If you do not want to reset the code, turn the
TUNE/SOUND switch to display "CANCEL" and then
press the TUNE/SOUND switch again.
Text message
You can change what is shown on the display when the satellite
radio tunes into a channel.
Press the DISP button repeatedly to change to your desired dis-
play mode. The order is:Channel Number + Channel Name →
Category Name → Artist Name → Song Title → Composer
Name
NOTE
Category name can also displayed by pressing the PTY
button.
I n f o r ma t i o n P r o v i d e d b y :
Advertisement
Chapters
Table of Contents
