Mitsubishi 2013 Outlander Service Manual page 222

To permanently set the non-display mode
1. Turn the ignition switch to the "ON" position or put the
operation mode in ON.
CAUTION
!
For safety reasons, do not perform the following
operations with the engine running.
2. Put the gearshift lever or the selector lever in the "R" posi-
tion.
3. Press and hold down the switch (1) (for about 15 sec-
onds).
While you keep the switch pressed, the orange indicator
(2) comes on. When the image goes off, the non-display
mode setting is completed.
To change the language of warning text (3)
1. Turn the ignition switch to the "ON" position or put the
operation mode in ON.
CAUTION
!
For safety reasons, do not perform the following
operations with the engine running.
2. Put the gearshift lever or the selector lever in the "R" posi-
tion.
3. Press and hold down the switch (1) to enter language
selection mode (for 6 to 11 seconds).
In this mode, the image appears and the green indicator
(2) comes on.
4. Press the switch until the desired language appears on the
display.
Each time you press the switch, the language will change
to the next one. When the warning text flashes, setting is
completed.
I n f o r ma t i o n P r o v i d e d b y :
Features and controls
3
3-125