Operating The Nēo 350P - moon 350P Owner's Manual

Operating the Nēo 350P
We recommend leaving your Nēo 350P powered up at
all times to maintain optimal performance. When you
plan on being away for a few days, it may not be a bad
idea to power off your preamplifier. Please keep in mind
that once fully "broken-in", your 350P requires several
hours of operation
performance after powering it up again.
Turning on your Nēo 350P for the first time
Prior to turning the preamplifier on for the first time,
make sure that every cable is properly connected to
avoid any problems. Flick the main rocker switch,
14
350P Nēo
Series
before reaching optimal
located on the rear panel, labeled "POWER" to the '1'
(on) position to place your 350P in to standby mode.
Next, briefly press the push button labeled "Standby"
located on the front panel. You will hear a very faint
click sound confirming that everything is in order. The
blue LED on the front panel will illuminate, indicating
that the 350P is now powered up and ready for use.
On and Off Sequence
To avoid having any annoying noises (ie. "thumps" and
"pops") emanate from your speakers when powering
your 350P on or off, you should always power up your
350P prior to powering up your amplifier. As well,
always power down your 350P after powering down
your amplifier(s).