Table of Contents
Advertisement
Safety Instructions
1.
Read these safety instructions carefully.
2.
Keep this user manual for later reference.
3.
Disconnect this equipment from AC outlet before cleaning. Do not use liquid or
spray detergents for cleaning.
4.
For pluggable equipment, the power outlet shall be installed near the equipment
and shall be easily accessible.
5.
Keep this equipment away from humidity.
6.
Put this equipment on a reliable surface during installation. Dropping it or letting
it fall could cause damage.
7.
Do not leave this equipment in an environment unconditioned where the storage
temperature under 0
equipment.
8.
The openings on the enclosure are for air convection hence protect the equip-
ment from overheating. DO NOT COVER THE OPENINGS.
9.
Make sure the voltage of the power source is correct before connecting the
equipment to the power outlet.
10.
Place the power cord in a way that people can not step on it. Do not place any-
thing over the power cord. The voltage and current rating of the cord should be
greater than the voltage and current rating marked on the product.
11.
All cautions and warnings on the equipment should be noted.
12.
If the equipment is not used for a long time, disconnect it from the power source
to avoid being damaged by transient over-voltage.
13.
Never pour any liquid into ventilation openings. This could cause fire or electri-
cal shock.
14.
Never open the equipment. For safety reasons, the equipment should be
opened only by qualified service personnel.
15.
If any of the following situations arises, get the equipment checked by service
personnel:
a.
The power cord or plug is damaged.
b.
Liquid has penetrated into the equipment.
c.
The equipment has been exposed to moisture.
d.
The equipment does not work well or you cannot get it to work according to
user manual.
e.
The equipment has been dropped and damaged.
f.
The equipment has obvious signs of breakage.
16.
CAUTION: The computer is provided with a battery-powered real-time clock cir-
cuit. There is a danger of explosion if battery is incorrectly replaced. Replace
only with same or equivalent type recommended by the manufacturer. Discard
used batteries according to the manufacturer's instructions.
17.
THE COMPUTER IS PROVIDED WITH CD DRIVES COMPLY WITH APPRO-
PRIATE SAFETY STANDARDS INCLUDING IEC 60825.
C (32
F) or above 40
°
°
CLASS 1 LASER PRODUCT
KLASS 1 LASER PRODUKT
iii
C (104
F), it may damage the
°
°
ACP-2000MB User Manual
Advertisement
Table of Contents
